ROOM PROBE (code SND-T/H/R)
TEMPERATURE AND HUMIDITY SENSORS
Active microprocessor sensor for measuring the ambient temperature and relative humidity.
Temperature and humidity room probes are compatible with the main recessed domestic series.
Each sensor is coded with an address that allows the simultaneous use of multiple sensors on the same communication bus (Modbus RTU). These probes are connected to the TSH or TST control unit through the Modbus interface.
|T Room probes||SND-T||T sensor, Modbus, wall mounted box 503|
|TH Room probes||SND-TH||T/H sensor, Modbus, wall mounted box 503|
|T Room probes with relay||SND-TR||T Sensor with relay, Modbus, wall mounted box 503|
|TH Room probes with relay||SND-THR||T/H Sensor with relay, Modbus, wall mounted box 503|
|T - TH - THR probes hole cover||COP||Perforated hole cover for T/H and THR sensor Modbus|
OUTDOOR T PROBE (code SND-EXT)
DIGITAL TEMPERATURE SENSOR IN AIRTIGHT CONTAINER
This probe performs temperature measurements between -55°C and 125°C with an accuracy of ± 0,5.
Each sensor is coded with a unique 64bit address that allows the simultaneous use of multiple sensors on the same communication bus.
CLIMATE SENSOR (code SND-VOCTH)
CO2, VOC, TEMPERATURE AND HUMIDITY SENSOR
This sensor detects the main room parameters: air humidity, temperature and quality (VOC). The CO2 concentration is calculated from the measured parameters.
Digital sensors are used as measuring elements for detecting the relative humidity of air and temperature, in order to ensure correct measurement results.
The air quality is detected by a mixed gas sensor (VOC).
Together with the VOCs (a value that is difficult to interpret for most), an IAQ air quality index is provided. It is a number that, based on the range, can indicate air saturation and therefore the quality according to regulations.
TH WIRELESS PROBE (code Z-TH-SENS)
BATTERY-POWERED TEMPERATURE AND HUMIDITY SENSOR
- Firmware upgrade support.
- Built-in Z-Wave 5th GEN chip.
- Max. 5 years battery life.
- Security – AES 128 bit encryption.
- CE/FCC/Z-Wave Plus certified.
WIRELESS DOOR/WINDOW PROBE (code SND-WLS-O/C)
WINDOW OPENING DETECTION SENSOR
It is used to increase the degree of energy efficiency. The “Energy Saving” mode is activated automatically when the window is open. This sensor is especially suitable for accommodation facilities.