Climate sensors for temperature and humidity control
Room sensors are a careful selection of temperature and humidity sensors has been done in order to satisfy the specific thermo-regulation needs in buildings with Termogea systems.
Besides PTC room sensors, our bus connected sensors (1-Wire and Modbus) allow great scalability in terms of number of zones and very simple installations.
1-WIRE ROOM SENSORS
Digital temperature sensor in watertight case.
This room sensor can measure temperature in a range between -55°C and 125°C with a precision of ± 0,5°C.
Every sensore has a unique identifier 64 bit code that allows the use of more sensors on the same communication bus.
- One communication bus
TEMPERATURE / HUMIDITY
Active sensor with a micro-controller to measure the ambient temperature and relative humidity.
ModBus RTU protocol (RS485).
PT100 PROBE ROOM SENSORS
3-wires PT100 thermistor with a IEC751 class B compatible PT100 element.
Sheath made of flexible teflon insulation conductor.
PT100 IMMERSION PROBE ROOM SENSORS
PT100 immersive thermoresistance with three wires with PT100 element according to IEC 751 class B with a wide operating range up to 650 ° C.
Painted die-cast aluminum head and thread.
PT100 probe, output current 4-20 mA
CO2, VOC, TEMPERATURE & HUMIDITY
Sensor with microprocessor control for the detection of the main parameters of the environment.
For this purpose, the air humidity values are measured together with temperature, CO2 concentration and air quality (VOC).
A digital sensor is used as a measuring element for detecting relative air humidity and temperature to ensure accurate measurement results.
Air quality is measured based on a mixed gas sensor.
The CO2 content of the air is detected by the NDIR optical sensor (non-dispersive infrared technology).
Available in two versions: with or without display.