SENSORS

A careful selection of temperature and humidity sensors has been done in order to satisfy the specific thremo-regulation needs in buildings with Termogea systems.

Besides PTC sensors, our bus connected sensors (1-Wire and Modbus) allow great scalability in terms of number of zones and very simple installations.

 

1-WIRE SENSOR

TEMPERATURE

Digital temperature sensor in watertight case.

It can measure temperature in a range between -55°C and 125°C with a precision of ± 0,5°C .

Every sensore has a unique identifier 64 bit code that allows the use of more sensors on the same communication bus.

  • One communication bus

MODBUS SENSOR

TEMPERATURE / HUMIDITY

Active sensor with a micro-controller to measure the ambient temperature and relative humidity.

ModBus RTU protocol (RS485).

PT100 PROBE

TEMPERATURE

3-wires PT100 thermistor with a IEC751 class B compatible PT100 element.

Sheath made of flexible teflon insulation conductor.

PT100 IMMERSION PROBE

TEMPERATURE

PT100 immersive thermoresistance with three wires with PT100 element according to IEC 751 class B with a wide operating range up to 650 ° C.

Painted die-cast aluminum head and thread.

PT100 probe, output current 4-20 mA

CO2 SENSOR

CO2, VOC, TEMPERATURE & HUMIDITY

Sensor with microprocessor control for the detection of the main parameters of the environment.

For this purpose, the air humidity values ​​are measured together with temperature, CO2 concentration and air quality (VOC).

A digital sensor is used as a measuring element for detecting relative air humidity and temperature to ensure accurate measurement results.

Air quality is measured based on a mixed gas sensor.

The CO2 content of the air is detected by the NDIR optical sensor (non-dispersive infrared technology).

Available in two versions: with or without display.